Owner's manual

Page 9;&(%$*4.8"4,7%<'*#$"&8#=%/7*,#*%4,77%>?@@@?@AA?BCDC1Item 63749 56861
EF;6GHIJ6KFGLIMNFLMG6MFMO6 EJ6OL;LOFGLIME
N,"8$*8,84*
GI%JK6!6MG%E6KLI\E%LM_\KH%;KIN%GIIS%;FLS\K6-%%T&%8&$%'#*%9,5,3*9%*<'"/5*8$1%%
L2%9,5,3*%&(%,+8&(5,7%&/*(,$"&8%&44'(#=%.,X*%$.*%/(&+7*5%4&((*4$*9%+*2&(*%2'($.*(%'#*1
R6;IK6%6FOZ%\E6=%"8#/*4$%$.*%3*8*(,7%4&89"$"&8%&2%$.*%$&&71%%O.*4V%2&(%7&&#*%
.,(9),(*=%5"#,7"385*8$%&(%+"89"83%&2%5&X"83%/,($#=%4(,4V*9%&(%+(&V*8%/,($#=%9,5,3*9%
*7*4$("4,7%)"("83=%,89%,8U%&$.*(%4&89"$"&8%$.,$%5,U%,22*4$%"$#%#,2*%&/*(,$"&81
M&$*- Replace the Lens Cover(s) if they are cracked, scratched, soiled, pitted or damaged in any way. For
additional information regarding the parts listed in the following pages, refer to Parts List and Diagram on page 11.
;(&8$%S*8#%O&X*(%K*/7,4*5*8$
1. Squeeze the Lens Holder (F) latches inside
the Helmet at the base of the Lens Holder
together and pull the bottom of the Lens Holder
towards the inside of the helmet to remove.
S*8#%
Z&79*(%
S,$4.
S*8#%
Z&79*(%`;a
;"3'(*%Q-%%S*8#%Z&79*(%S,$4.*#
2. Remove Front Lens Cover (C) from
Shell (A). Carefully remove Gasket (B)
from Front Lens Cover. Refer to Parts
List and Diagram on page 11.
3. Remove any protective film from both
sides of the new Lens Cover.
4. Install new Front Lens Cover into Gasket and
assemble Lens, Gasket, and Lens Holder into
Shell the same way they were removed.
MIGLO6- Front lens must be in place during
welding. Weld spatter will permanently damage
Auto-Darkening Filter and voids warranty.
L8#"9*%S*8#%O&X*(%K*/7,4*5*8$
1. Remove the old Inside Lens Cover (E)
by pulling it up at the finger notch.
S*8#%
Z&79*(%`;a
L8#"9*%
S*8#%
O&X*(%`6a
2"83*(%8&$4.
;"3'(*%Z-%%L8#"9*%S*8#%O&X*(%;"83*(%M&$4.
2. Remove any protective film from both
sides of the new Lens Cover.
3. Line up the new Inside Lens Cover with the flanges
at the sides of the lens and snap it into place.