USER MANUAL VOLCANO 880 LUMEN CAMPING LED FLASHLIGHT FC-B45RBW
Thank you for choosing Vulta. Designed for camping and hunting applications, as well as emergency scenarios, the Vulta FCB45RBW is a high-output flashlight that produces a maximum 880 lumens of bright white light capable of penetrating deep into the woods. In addition to the main CREE XM-L2 LED, the FCB45RBW is equipped with an array of secondary LEDs that provide red or blue light, which is perfect for reading maps, tracking animals, and illuminating paths when your eyes are adjusted to the dark.
PRECAUTIONS ⚠⚡ • Please read and follow these instructions and keep this manual in a safe place. • This flashlight is extremely bright and can cause temporary or even permanent blindness. Do not shine the flashlight in the eyes of any person or animal. When turning on the flashlight, make sure to point it down or away from you and anyone else. • The surface of this product can become hot after prolonged use. Be careful when touching it and make sure to keep it away from anything flammable or combustible.
• Always install AA batteries of the same type, brand, and age. Do not combine different types or brands, or old and new batteries. This can cause the batteries to leak, overheat, or explode. • Install the batteries in the proper orientation as indicated by the instructions in this manual. • This product is waterproofed for freshwater only. If it comes into contact with salt water, immediately dry the flashlight and remove the batteries, reassemble, and rinse with freshwater.
PRODUCT DIAGRAM A A LEDS B LAMP HEAD C MODE BUTTON D POWER BUTTON E GRIP F O-RING G TAILCAP H LANYARD EYELETS B C D E F G H Also Included: DIFFUSER CAP USER MANUAL LANYARD TWO-YEAR LIMITED WARRANTY SPARE O-RING (×2) VULTA VOLCANO 05
INSTALLING BATTERIES The FC-B45RBW is powered by four AA batteries—either alkaline, NiCd, or NiMH. Note: Make sure to load the batteries with the positive and negative terminals facing the proper directions. The FC-B45RBW has a reverse-polarity protection circuit that prevents damage due to improper battery installation, but the flashlight will not turn on if the batteries are oriented incorrectly. Lithium batteries are not recommended for this flashlight. To install batteries, follow these steps: 1.
OPERATION The FC-B45RBW employs a dual-button sideswitch system to turn on the flashlight and engage a total of eleven modes. POWERING ON THE FC-B45RBW To turn on the FC-B45RBW, press the Power button. Upon powering on, the flashlight will enter Turbo mode for 3 minutes before entering High mode. The next time you power on the flashlight, it will enter the most recent normal (noncolor) constant-output mode, including Firefly mode.
start with the flashlight either turned off or in any normal (noncolor) mode. Press and hold the mode button for approximately two seconds until Firefly mode activates. To exit this setting, press the Mode button. To turn the flashlight off, press the Power button. SOS: In SOS mode, the flashlight will blink brightly in the international Morse code distress signal pattern (· · · – – – · · ·). To enter SOS mode, start with the flashlight powered on, and then double-press the Mode button.
or an alternating red and blue strobe with a bright white pulse. To enter Color mode, start with the flashlight turned off. Press and hold the power button for approximately two seconds, until the flashlight emits a constant red beam. To cycle through the color modes, press the mode button repeatedly. To turn off the flashlight, press the power button. ELECTRONIC LOCK-OUT The electronic lock-out feature prevents accidental activation during storage and transport.
To install the diffuser cap, slowly fit it onto the lamp head. It may help to rotate the cap slightly while attaching it. THE LANYARD You can attach and wear the included lanyard to help prevent accidental drops and to free up a pocket. To attach the lanyard, thread it through one of the lanyard eyelets on the flashlight’s tailcap. O-RING MAINTENANCE The FC-B45RBW’s O-ring is installed on the threaded portion to help seal out water.
SPECIFICATIONS OUTPUT Turbo, Strobe, SOS: 880 lm High: 500 lm, Medium: 200 lm Low: 60 lm, Firefly: 1 lm Red: 28 lm, Blue: 20 lm BEAM INTENSITY 13,200 cd LED TYPE Primary: CREE XM-L2 Secondary: Six red, six blue POWER SOURCE Four AA batteries (alkaline, NiCd, NiMH; lithium batteries not recommended) WORKING VOLTAGE 2.8–6 V RUNTIME Turbo: Automatically switches to High after 3 min. of continuous use High: 1.6 hr., Medium: 5 hr. Low: 13 hr., Firefly: 450 hr. Red: 11 hr., Blue: 15 hr.
TWO-YEAR LIMITED WARRANTY This VULTA product is warranted to the original purchaser to be free from defects in materials and workmanship under normal consumer use for a period of two (2) years from the original purchase date or thirty (30) days after replacement, whichever occurs later.
