Owner`s manual
DISH
4
ANTENNA CONFIGURATION
You must congure the antenna to work with your DISH satellite service. Doing this will allow the
KING Flex to lock on the correct satellites to receive your programming and also enable automatic
satellite switching via the receiver’s remote control for multi-satellite service.
Antenna conguration is a one time procedure that MUST BE COMPLETED before using your KING
Flex antenna. To congure your antenna, do the following:
1. Press POWER to turn on KING Flex controller. The COAX CONNECTION light will ash 10
times and then turn on, and the SCAN PROGRESS lights will ash 3 times to indicate the
selected service conguration.
2. Simultaneously press and hold POWER and SCAN for ve seconds.
The COAX CONNECTION light and the SCAN PROGRESS lights that indicate the currently
selected service will begin ashing.
3. Press SCAN repeatedly to scroll thru the available service provider options.
Section 2 ANTENNA AND ALARM CONFIGURATION
NOTE: If you have a DISH receiver ViP211z, ViP211k, ViP211 or 411, FIRST choose the TAILGATER
MODE setting as instructed on these two pages, and then continue with Tailgater Mode
(Section 6, page 14).
To verify the current service conguration without changing it, perform steps 1-2 and 4-6.