Owner`s manual

DISH

1. Turn on the TV and satellite receiver.

2. Your KING Flex controller should be on from the conguration process on pages 4-5. If not,

press POWER and wait for the COAX CONNECTION light to remain on.

Press and hold SCAN for 3 seconds.

The antenna will locate all of the appropriate satellites before completing the search process.

After the antenna acquisition process is complete, specic SCAN PROGRESS lights will

turn on to indicate which satellites have been found (see chart on page 11).

If you congured the antenna for DISH SD and HD and the antenna cannot acquire the

110, 119, and 129 satellites, you may need to congure the antenna for DISH SD and

HD Alternate (pages 4-5).

IMPORTANT! YOU MUST HAVE COMPLETED THE ANTENNA CONFIGURATION ON PAGES 4-5 BEFORE

CONTINUING BELOW.

NOTE: For automatic satellite switching, KING recommends using a DISH model 311 receiver for DISH SD. For DISH

SD and HD, you can use receiver models ViP211z, ViP211k, ViP211, and 411, but we highly recommend using

Tailgater mode with these receivers for simplied operation with the receiver’s built in Tailgater interface.

If you do not have a clear view of the satellites, the switch will not load correctly.

The SW21 and SW64 switches are a receiver software conguration that is loaded into the receiver after

successfully running a check switch test with the dish locked on and congured for the appropriate service.

This one time procedure will not need to be repeated after successful installation, unless:

a) check switch test is run again while the receiver is connected to a home dish system.

b) check switch test is run when the receiver is not connected.

c) you travel outside the coverage area of either DISH SD and HD or DISH SD and HD Alternate and switch

to the other.

d) you are parked in an area where the selected satellites are blocked, but are able to select alternate

satellites and get signal.

Section 3 RECEIVER CONFIGURATION

IMPORTANT!

The antenna unit requires a

“direct line of sight” to the

satellites for signal reception.

Any tall objects can block the

signal from reaching the antenna.