Owner`s manual
DISH
7
3. On the receiver remote, press MENU, 6, 1, 1.
4. Highlight “Check Switch.”
Press SELECT on your remote.
NOTE: Some receivers may prompt you to select
“Check Switch” a second time to initiate
the test.
Screen graphics may vary.
5. Make sure “SuperDISH” and “Alternate” boxes
are NOT selected.
NOTE: Not all receivers will display a screen with
options that include “SuperDISH” and
“Alternate” boxes.
6. Highlight “Test.”
Press SELECT on your remote.
The receiver will perform a check switch test. This process can take a little while so
PLEASE BE PATIENT.
7. When test is complete, a screen similar to one below or on the next page should appear.
After screen verication, continue with check switch test procedure on next page.
Because receivers are always changing, screen graphics may vary.
DISH SD
MUST SHOW
“SW21”
NO “X”s