Owner`s manual

DISH
12
Section 5 2ND RECEIVER OPERATION
INITIAL SETUP FOR SECOND RECEIVER
1. With the second receiver disconnected from
the antenna unit’s AUX port coax, use your
DISH remote control and press MENU, 6, 1, 1
to display the Point Dish screen.
2. Use the arrow buttons on the remote
to highlight “Check Switch.”
Press SELECT on your remote.
4. Connect second receiver to antenna
unit’s MAIN port and run check switch
again using steps above.
3. Verify “SuperDISH” and “Alternate”
are not selected.
Verify “Test” is highlighted.
Press SELECT on your remote.
Wait for check switch test to nish.
Second receiver must
be disconnected during
initial check switch test.
Connect to MAIN port.