Owner`s manual

DISH
20
1. If your KING Flex controller is not on, press POWER and wait for the COAX CONNECTION
light to remain on.
2. Plug your receiver and TV into a 110 volt AC power source.
The green power light on your receiver should illuminate or begin cycling on and off.
Wait for the green light to turn solid. This may take up to two minutes.
If it does not turn solid, power on your receiver using the front panel POWER button.
(On “z” models, this is located behind the door panel.)
3. Plug in and turn on your TV.
In your TV’s input selection menu, choose the input that matches the connection from your
receiver (example: if using an HDMI cable from your receiver, choose the HDMI input on your
TV). See your TV owner’s manual for details.
IMPORTANT!
The antenna unit requires a
“direct line of sight” to the
satellites for signal reception.
Any tall objects can block the
signal from reaching the antenna.
IMPORTANT! You must have chosen Tailgater Mode on pages 4-5.
Your local channels may not be available when traveling outside your home area.
If your receiver is NEW AND UNACTIVATED, start on page 14.
STANDARD TAILGATER OPERATION