Owner`s manual

Bell TV

ANTENNA CONFIGURATION

You must congure the antenna to work with your Bell TV satellite service. Doing this will allow the

KING Flex to lock on the correct satellites to receive your programming and also enable automatic

satellite switching via the receiver’s remote control for multi-satellite service.

Antenna conguration is a one time procedure that MUST BE COMPLETED before using your KING

Flex antenna. To congure your antenna, do the following:

1. Press POWER to turn on KING Flex controller. The COAX CONNECTION light will ash 10

times and then turn on, and the SCAN PROGRESS lights will ash 3 times to indicate the

selected service conguration.

2. Simultaneously press and hold POWER and SCAN for ve seconds.

The COAX CONNECTION light and the SCAN PROGRESS lights that indicate the currently

selected service will begin ashing.

3. Press SCAN repeatedly to scroll thru the available service provider options.

Section 2 ANTENNA AND ALARM CONFIGURATION

NOTE: To verify the current service conguration without changing it, perform steps 1-2 and 4-6.