Owner`s manual
Bell TV
6
1. Turn on the TV and satellite receiver.
2. Your KING Flex controller should be on from the conguration process on pages 4-5. If not,
press POWER and wait for the COAX CONNECTION light to remain on.
Press and hold SCAN for 3 seconds.
The antenna will locate all of the appropriate satellites before completing the search process.
After the antenna acquisition process is complete, specic SCAN PROGRESS lights will
turn on to indicate which satellites have been found (see chart on page 9).
IMPORTANT! YOU MUST HAVE COMPLETED THE ANTENNA CONFIGURATION ON PAGES 4-5 BEFORE
CONTINUING BELOW.
NOTE: If you do not have a clear view of the satellites, the switch will not load correctly.
The SW21 switch is a receiver software conguration that is loaded into the receiver after successfully running
a check switch test with the dish locked on and congured for the appropriate service.
This one time procedure will not need to be repeated after successful installation, unless:
a) check switch test is run again while the receiver is connected to a home dish system.
b) check switch test is run when the receiver is not connected.
c) you are parked in an area where the selected satellites are blocked, but are able to select alternate
satellites and get signal.
Section 3 RECEIVER CONFIGURATION
IMPORTANT!
The antenna unit requires a
“direct line of sight” to the
satellites for signal reception.
Any tall objects can block the
signal from reaching the antenna.
NOTE: Because receivers are always changing, screen graphics may vary.