Owner`s manual

Bell TV
7
3. On the receiver remote, press MENU, 6, 1, 1.
4. Highlight “Check Switch.”
Press SELECT on your remote.
NOTE: Some receivers may prompt you to select
“Check Switch” a second time to initiate
the test.
5. Make sure “SuperDISH” and “Alternate” boxes
are NOT selected.
NOTE: Not all receivers will display a screen with
options that include “SuperDISH” and
“Alternate” boxes.
6. Highlight “Test.”
Press SELECT on your remote.
The receiver will perform a check switch test. This process can take a little while so
PLEASE BE PATIENT.
7. When test is complete, a screen similar to one below should appear.
Bell TV SD Bell TV SD and HD
MUST SHOW
“SW21”
NO “X”s
“NO SWITCH
DETECTED”
or
“INSTALLED
DEVICE
UNKNOWN”
or
similar
If the indicated results are not obtained, go back to Step 3 and run test again. Contact KING if
the check switch fails to load after 4 attempts.
8. When the installation summary shows the successful check switch test results, save the
settings, exit to the main menu screen and wait for programming to download.
9. Conguration is complete. Go to page 8, OPERATION.