Owner`s manual

Bell TV

SCAN FOR SATELLITES

4. Press and hold SCAN for 3 seconds.

• The antenna will scan for the selected satellites. The four SCAN PROGRESS lights will

cycle on and off to indicate a scan is in progress.

• As satellites are located, the corresponding SCAN PROGRESS lights will turn on (see

below).

• When scan is complete, the appropriate lights will turn on to show which satellites were

found.

• Wait for the program guide to download and then select your desired channel.

NOTE: If you move the antenna unit, you will have to re-acquire the satellites by repeating the scan process. The

KING Flex will go into “sleep mode” after 15 minutes and the COAX CONNECTION light will dim. Press

POWER to wake unit up if necessary, i. e. the unit is in sleep mode, you move the unit, and wish to rescan for

satellites.

To turn the unit off at any time, press POWER for 3 seconds.

If you are using a second receiver, see SECOND RECEIVER OPERATION on page 10.