Owner`s manual

Bell TV
11
6. After successfully saving the results,
connect the second receiver to the
AUX port.
5. When test is complete, highlight “Save.”
Press SELECT on your remote.
DOWNLOADING PROGRAMMING TO THE SECOND RECEIVER
1. With the second receiver now connected, and the antenna locked on (see OPERATION
section), re-set the second receiver by pressing the POWER button on the front panel for 10
seconds. The TV picture will go away and should reappear within two minutes.
The receiver will then download the program guide to show only the channels available on the
current satellite as determined by the channel selected on the main receiver. Downloading the
new program guide can take up to ve minutes to complete.
The channels available on the second receiver are determined by the channel/satellite selected on
the main receiver. For example, if you select a channel on the main receiver that is broadcast from
the 82 satellite, then the second receiver will be able to display any channel broadcast from the 82
satellite.
If you switch channels on the main receiver to one that is broadcast from a different satellite, (i.e. your
channel was broadcast from satellite 82 but your new channel is broadcast from the 91), the antenna
will automatically switch to the new satellite and programming will be lost on the second receiver until
you either:
• Select a channel on the main receiver that is broadcast from the previous satellite (satellite
82 in this example).
(or)
• Reset the second receiver to download the program guide for the newly selected satellite
(satellite 91 in this example).
Connect to AUX port.