Owner`s manual

DIRECTV

4. When the correct lights turn on to show your desired satellite conguration, simultaneously

press and hold POWER and SCAN for ve seconds.

Your antenna conguration will be saved. All SCAN PROGRESS lights will turn off and the

COAX CONNECTION light will continue to ash.

The unit will now enter Alarm Conguration mode.

ALARM CONFIGURATION

After entering Alarm Conguration Mode using the previous steps, audible beeping will conrm

the alarm condition:

Single Beep (beep...beep...beep)............................Alarm is OFF.

Double Beep (beep beep...beep beep) ...................Alarm is ON.

5. Press and release SCAN to toggle between the on and off conditions.

Beep pattern will change to indicate new condition.

6. When alarm is in desired condition, press POWER and SCAN for 5 seconds to exit

Alarm Mode. Alarm condition will be saved. COAX CONNECTION light will turn solid and

SCAN PROGRESS lights will stay off.

7. Set your receiver options as follows:

DIRECTV SD

If you have a newer receiver or current software, choose the following dish

conguration settings (do this through the receiver’s satellite set-up menu screens):

Switch Type: 02:Multiswitch • Dish Type: 01: 18” Round

DIRECTV SD with Locals

If you have a newer receiver or current software, choose the following dish

conguration settings (do this through the receiver’s satellite set-up menu screens):

Switch Type: 02:Multiswitch • Dish Type: 02: 3-LNB (18 x 20”)

8. Go to page 6.

Notes on Alarm Feature

When alarm is enabled: If the coax cable is disconnected from the antenna unit or the controller while the system is

turned on or in standby mode, the controller will sound an audible alarm.

To turn off the alarm when it is sounding, press POWER until the controller turns off.

This unit is shipped from the factory with the alarm feature in the ON condition.

If you wish to change the alarm from its previous state, perform steps 1-2 and 4-6 on these two pages.

IMPORTANT! The KING Flex will not work

with SWM only receivers.

(older receivers: choose round dish-1 satellite)

(older receivers: choose oval dish-2 satellites)