Installation Instructions DecoFrame PICTURE FRAME FOR LCD OR PLASMA TV MONITOR 09/24/07 DCF-INSTL_A
IMPORTANT SAFETY INSTRUCTIONS Basic safety precautions should always be followed; including the following: ♠ ♠ ♠ ♠ ♠ Read and understand all instructions before proceeding with the installation and operations. Be certain that the supporting structure is sound and capable of carrying the weight as required. Seek qualified electricians to perform electrical requirements. Obtain proper lifting mechanism to raise and hold the unit steady for installation.
FEATURES AND CONSIDERATIONS ⇒ TV MUST BE HUNG TO WALL (WALL MOUNT BRACKETS NOT SUPPLIED) BY INSTALLERS. ⇒ DECOFRAME TO BE ATTACHED TO TV. ⇒ DECOFRAME DOES NOT COMPLETELY COVER SIDES, TOP AND BOTTOM OF TV. ⇒ DECOFRAME REVEALS ACTUAL TV’S VIEWING IMAGE AND COVERING ALL OTHER PARTS OF TV. ⇒ DECOFRAME IS NOT RECOMMENDED FOR TV WITH SIDE OR BOTTOM SPEAKERS. ⇒ DECOFRAME IS SIZE SPECIFIC TO TV’S DIAGONAL. ⇒ DECOFRAME IS EQUIPTED WITH PROTECTIVE FOAM PADS TO CUSHION BEZEL CONTACT.
INSTALLATION Measure the TV upper bezel. It must be 3 1/2 inches or less as shown in Figure 1. Place the DecoFrame front face down on a flat and cleaned surface. Loosen the thumb screws and move the Horizontal bracket to match the TV upper bezel dimension (Figure 3). Tighten the thumb screw to lock the Horizontal bracket in place. Do not over tighten the screws. Lift the DecoFrame up and flip the Velcro straps to the front face to keep them clear of the TV.
Hang DecoFrame back onto TV. Place IR control module in a convenient location with the IR receiver outside to be seen by the TV remote control. Plug the IR wall transformer to an AC 120V outlet. Aiming the TV remote control at the IR receiver and test the remote control operations. The TV remote control is expected to operate as normal. If the TV does not respond to the remote control commands; check the followings: ♣ Check that IR emitter is in front of TV sensor.
Figure 3 Complete DecoFrame Over TV – Rear View PART LIST 1 COMPLETE DECOFRAME ASSEMBLY 1 IR REPEATER KIT 5