User manual

Chapter 5 Register Descriptions
VXI-MXI-2 User Manual 5-56 © National Instruments Corporation
8 ENABLE Enable Interrupt
This bit controls whether the interrupt is enabled
or disabled when writing to the DMAIER. Write
this bit with a 1 to enable the interrupt or a 0 to
disable the interrupt. The DMAIEN bit should
always be written with a 1. This bit always
returns a 0 when read.
7-0 0 Reserved
These bits are reserved. Write each of these bits
with 0 when writing the DMAIER. The value
these bits return when read is meaningless.