User's Manual

Maintenance
8–12
VX1410A & VX1420A IntelliFrame Mainframe Instruction Manual
To remove the power supply from the mainframe you must first remove the fan
assembly. Perform Procedure 2 on page 8–6, to remove the fan assembly then
continue with the following steps:
1. Using the handle on the power supply, firmly pull out the power supply from
the rear of the mainframe.
2. Remove two 3/32 hex-drive screws and washers to remove the handle from
the power supply.
Power supply
Handle
Mainframe
Figure 8–9: Removing the power supply
The card guides at the top and bottom of the mainframe are very similar. The
main difference is that the bottom guides (IntelliGuides) include the spring-
loaded shutters to redirect air into the mainframe. The procedure for removing
both guides is identical. Refer to Figure 8–10 while performing the following
steps:
1. Use a small flat blade screw driver to pry up the tab of the card guide at the
front of the mainframe, being careful not to damage the card guide or the
mainframe.
2. Gently pull the card guide forward until it pops out of place.
3. Remove the card guide.
Procedure 4: Removing
the Power Supply
Procedure 5: Removing
the Card Guides