Universal Remote User Manual

276 VT1422A Command Reference Chapter 7
DIAGnostic
DIAGnostic
The DIAGnostic subsystem allows special operations to be performed that are not
standard in the SCPI language. This includes checking the current revision of the
Control Processor's firmware and that it has been properly loaded into Flash Memory.
Subsystem Syntax DIAGnostic
:CALibration
:SETup
:MODE 0 | 1
:MODE?
:TARe
[:OTD]
:MODE 0 | 1
:MODE?
:CHECksum?
:CONNect <source>,<mode>,(@<ch_list>)
:CUSTom
:MXB <slope>,<offset>,(@<ch_list>)
:PIECewise <table_range>,<table_block>,(@<ch_list>)
:REFerence
:TEMPerature
:IEEE 1 | 0
:IEEE?
:INTerrupt
[:LINe] <intr_line>
[:LINe]?
:OTDetect
[:STATe] 1 | 0 | ON | OFF,(@<ch_list>)
[:STATe]? (@<channel>)
:QUERy
:SCPREAD? <reg_addr>
:REMote
:USER
:DATA <user_data_block>,(@<ch_list>)
:DATA? (@<ch_list>)
:TEST
:REMote
:NUMber? <test_num>,<iterations>,(@<channel>)
:SELFtest? (@<channel>)
:SELFtest?
:VERSion?