Universal Remote User Manual

312 VT1422A Command Reference Chapter 7

OUTPut

The OUTPut subsystem is involved in programming source SCPs as well as

controlling the state of VXIbus TTLTRG lines 0 through 7.

Subsystem Syntax OUTPut

:CURRent

:AMPLitude <amplitude>,(@<ch_list>)

:AMPLitude? (@<channel>)

[:STATe] 1 | 0 | ON | OFF,(@<ch_list>)

[:STATe]? (@<channel>)

:POLarity NORMal | INVerted,(@<ch_list>)

:POLarity? (@<channel>)

:SHUNt 1 | 0 | ON | OFF,(@<ch_list>)

:SHUNt? (@<channel>)

:SOURce INT | EXT,(@<ch_list>)

:SOURce? (@<channel>)

:SHUNt? (@<channel>)

:TTLTrg

:SOURce TRIGger | FTRigger | SCPlugon | LIMit

:SOURce?

:TTLTrg<n>

[:STATe] 1 | 0 | ON | OFF

[:STATe]?

:TYPE PASSive | ACTive,(@<ch_list>)

:TYPE? (@<channel>)

:VOLTage

:AMPLitude <amplitude>,(@<ch_list>)

:AMPLitude? (@<channel>)

OUTPut:CURRent:AMPLitude

OUTPut:CURRent:AMPLitude <amplitude>,(@<ch_list>) sets the VT1505A

Current Source SCP channels specified by <ch_list> to either 488 µA or 30 µA.

This current is typically used for four-wire resistance and resistance temperature

measurements.

Note This command does not set current amplitude on SCPs like the VT1532A Current

Output SCP.