Universal Remote User Manual

380 VT1422A Command Reference Chapter 7
STATus
Initializing the
Status System
The following table shows the effect of Power-on, *RST, *CLS, and STATus:PRESet
on the status system register settings.
Subsystem Syntax STATus
:OPERation
:CONDition?
:ENABle <enable_mask>
:ENABle?
[:EVENt]?
:NTRansition <transition_mask>
:NTRansition?
:PTRansition <transition_mask>
:PTRansition?
:PRESet
:QUEStionable
:CONDition?
:ENABle <enable_mask>
:ENABle?
[:EVENt]?
:NTRansition <transition_mask>
:NTRansition?
:PTRansition <transition_mask>
:PTRansition?
The Status system contains four status groups
• Operation Status Group
• Questionable Data Group
• Standard Event Group
• Status Byte Group
This SCPI STATus subsystem communicates with the first two groups while
IEEE-488.2 Common Commands (documented later in this chapter) communicate
with Standard Event and Status Byte Groups.
SCPI
Transition
Filters
SCPI
Enable
Registers
SCPI Event
Registers
IEEE 488.2
Registers
ESE and SRE
IEEE 488.2
Registers
SESR and STB
Power-on preset preset clear clear clear
*RST none none none none none
*CLS none none clear none clear
STAT:PRESET preset preset none none none