Specifications

Subsystem Syntax CALibration
:CONFigure
:RESistance
:VOLTage <range>, ZERO | FS
:SETup
:SETup?
:STORe ADC | TARE
:TARE (@<ch_list>)
:RESet
:TARE?
:VALue
:RESistance <ref_ohms>
:VOLTage <ref_volts>
:ZERO?
CALibration:CONFigure:RESistance
CALibration:CONFigure:RESistance connects the on-board calibration reference
resistor to the Calibration Bus. A four-wire measurement of the resistor can be made
with an external “calibration DVM” connected to the H Cal, L Cal, H ohm, and L
ohm terminals on the Terminal Module or the VH, VL, W H, and W L terminals
on the Cal Bus connector.
VT1419A Command Reference
CALibration
208 Chapter 6
Figure 6-3: Levels of Working Calibration
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com