Installation Instructions

5. Start the vehicle– you should see the LEDs light up on the front of the device.
6. If for any reason you do NOT see the LEDs light up, with the device installed and engine running,
unplug the device and repeat steps 3 and 4.
7. Once you see the LEDs flashing – please leave the device plugged in for at least 5 minutes.
8. If your device has a SOLID Cellular light after 5 minutes - the SYNC process is complete. If not,
please POWER CYCLE (Instructions below) to restart SYNC process. Power LED will be solid red. OBD
LED will be slowly blinking. If you cannot see the LEDs during daytime, ignore this step and follow the
step below.