User's Manual

System Configuration Guide
www.vyyo.com
Adding a Modem to the WMTS – p. 60
5.3.2 Setting the WMTS Downstream Parameters
1. Select the WMTS Downstream Channel you wish to configure from the
left side of the window. In this example downstream channel 1 is
selected and all of its parameters are displayed in the right pane of the
window.
Bandwidth, modulation, and other parameters can be changed. Typically the
default values should be used with “Optimize channel parameters” unless
your system engineer indicates otherwise.
These parameters should be determined by the system engineer responsible
for the RF planning and are outside the scope of this manual.
Figure 5-24: Select the downstream channel and change its parameters