User's Manual

System Configuration Guide
www.vyyo.com
Adding a Modem to the WMTS – p. 69
5.5 Verifying the Modem Downstream and Upstream
Status
1. View the downstream status after the modem has successfully
completed registration by typing “dsdiag” to verify that the change took
effect and the modem is operating correctly: “QAM = LOCKED” and
“FEC = LOCKED” should appear as the last two lines. You must have
“operator” access rights to do this.
NOTE: this will only happen if the modem is in a place
where it can establish RF connectivity to the WMTS, e.g.,
hooked up to the cable plant.
Figure 5-33: Viewing the Modem Downstream Status