User's Manual

Installation and Safety Information
The following information is provided to ensure
safe operation of this equipment. Vyyo
assumes no liability in the event that the
customer fails to comply with the following
safety precautions and warnings.
System Power-on
AC System
DC System
AC System Power
The WMTS power supplies are factory wired for 115 ~ 220 VAC (2 X
200W). A power cords are provided to connect the unit to the power
source. To operate the WMTS, turn ON the power switch at the rear panel.
Warning!
Set the fuse selector on the rear panel to the proper position
(110V or 220V), before plugging in the power cord, or turning on the
WMTS.
DC System Power
1. When connecting DC power lines make sure to connect Ground line
first.
2. When disconnecting DC power lines – make sure to disconnect ground
last.
3.External Circuit Breaker (DuPole) should be used before
connection/removal of the power cable to/from the WMTS.
4. FUSE Replacement – Make sure to use same type and value fuse !
Note that UL requires use of AC ceramic high breaking capacity 10Amp
fuse.