User's Manual

Vyyo Installation Guide
www.vyyo.com
Configuring a T1 Connection – p. 85
6.2 Adding the T1 modem to the WMTS T1 Interface and
Assign Port(s)
NOTE: The WMTS Upstream and Downstream
parameters must be configured prior to performing this
procedure. In particular the Upstream “Voice Service
Type” must be set to “WAN” for an E1/T1 channel. See
Configuring a T1 Connection. This is done using the Vyyo
Configuration Tool. Before proceeding, launch the Vyyo
Configuration Tool as described in Launching the Vyyo
Configuration Tool.
1. Expand the WMTS tree in the left pane of the main Vyyo Configuration
Tool window. Then expand “Modems” to obtain a more informative
version of the window. If the modem is already connected, the tool will
detect it automatically and it will appear in the list under
“Modems->E1/T1” or “Modems->Data” by its MAC address; in this case
skip to Step 4. Otherwise you must add the modem to the list by
continuing this procedure.
Figure 6-11: Expand the WMTS Tree