User's Manual

Vyyo Installation Guide
www.vyyo.com
Configuring a T1 Connection – p. 89
7. When this screen appears, select the desired port on the WMTS E1/T1
interface card using the drop-down menu. This binds the T1 port on the
modem to its corresponding T1 port on the WMTS E1/T1 interface card
(inserted into the rear of the WMTS chassis).
Other parameters may be changed from the defaults shown in this
screenshot to create a “fractional T1” connection: the Framing parameter
must be set to ESF Framing or D4 Framing, and then you may set the
desired Time Slots range. Make sure that both the WMTS and Modem
port status are enabled.
Figure 6-18: Updating the Port Data
Select the port – all
assigned ports will
appear (only 1 in
this example)
Click the “Update” button
when done
To make this a fractional T1
connection select the specific T1
slots you wish to use by setting the
Framing parameter and choosing
the Time slot range
Select the desired WMTS port using
the pull down menu