DCAM550 ToF Camera User Manual -20210906

IEEE 802.3at-2009 standard also known as PoE+, which can provide up to 25.5W, or

IEEE 802.3bt-2018 standard also known as PoE++, which can provide up to 60W.

Otherwise the product may not work well at long range mode.

We can provide optional PoE switch or PoE injector to our customers, please try to

contact the sales for the quotation and more information.

Steps to Setup PoE Mode

As mentioned above, a PoE switch or PoE injector shall be in use to setup the PoE;

The steps are as below:

1. Mount the camera in an appropriate fixture, e.g. a camera bracket;

2. Plug one end of the Ethernet cable into the RK45 socket at the back of the camera,

and plug the RJ45 end into the Ethernet port of your PoE switch or PoE injector;

3. Connect the PoE switch or PoE injector to your host processor by Ethernet cable;

4. Connect the PoE switch or PoE injector to power source;

6.1.5 Standalone Mode Installation

This mode is for advanced users who require customization to the software and

application, the applications can run on the processor inside the camera, and output

the result data by either RS485 or EXT_OUTPUT pin. NRE fee shall be charged if you

need Vzense team to do software or application customization.

In this mode, the cable (VZENSE-MFP-6P-B) shall be used in this mode.