USER MANUAL Order Code: SPEA34 - DSR-10A Order Code: SPEA35 - DSR-12A Order Code: SPEA36 - DSR-15A ENGLISH
WARNING FOR YOUR OWN SAFETY, PLEASE READ THIS USER MANUAL CAREFULLY BEFORE YOUR INITIAL START-UP! CAUTION! Keep this equipment away from rain, moisture and liquids.
IMPORTANT: The manufacturer will not accept liability for any resulting damages caused by the non-observance of this manual or any unauthorised modification to the equipment. • Never let the power-cable come into contact with other cables. Handle the power-cable and all mains voltage connections with particular caution! • Never remove warning or informative labels from the equipment. • Do not open the equipment and do not modify the equipment.
Features • High impact molded polypropylene enclosure • Heavy duty dynamic switch mode power supply • Built-in highly efficient class D amplifier • 10”, 12” or 15” Mid-Low frequency transducers • 1” Compression high frequency driver • 80˚ x 60˚ Coverage pattern • Smooth response with high power • 5 Integral suspension points • Complete mounting solutions Specifications: DSR-10A DSR-12A DSR-15A Freq. Range(-10dB): 60Hz~19kHz 56Hz~19kHz 45Hz~19kHz Freq.
Specifications: DSR-10A Freq. chart: Dimensions: Block diagram: DSR-12A Freq. chart: Dimensions: Block diagram: DSR-15A Freq.
Installation on a Speaker Stand The speakers may only be installed on a speaker stand if the original speaker is equipped with an appropriate stand adaptor. Stands must only be installed on a plane area with a maximum inclination angle of 5˚. CAUTION: Speakers installed under the influence of horizontal forces, e.g. wind, can be impaired. This is why additional safety measures like attaching ballast weights have to be taken. If inclined tension cables or prolonged outriggers are used.
Overhead Installation If the speaker is to be installed with a mounting height of more than 1 meter (e.g. on a stage or framework), the speaker must always be secured with an appropriate secondary securing attachment. The installation must always be secured with a secondary safety attachment. e.g. an appropriate catch net. The secondary safety attachment must be constructed in a way that no part of the installation can fall down if the main attachment fails.
Secondary Attachment Please note: The Speaker(s) must always be secured with three appropriate eye bolts and three appropriate safety ropes. The eyelets and the safety ropes must always hold at least 12 times the weight of the speaker. Please note: Before installing the eye bolts, make sure that the thread is is always in perfect condition and free from dirt. Install the eye bolts in the threaded holes on the speaker. The eye bolts must be tightened until the stop position, hand tight with out any tools.
Wall Installation The speaker can only be installed on a wall, if the original speaker is equipped with an appropriate mounting point. Before attaching the speaker, make sure that the installation area can hold a minimum point load of 10 times the installations weight. (e.g. 13Kgs - 130Kgs point load). The durability of the installation depends very much on the material used at the installation area (building material), such as wood, concrete and brick etc.
9
10
