Datasheet

www.ti.com Connector and Test Point Descriptions
4 Connector and Test Point Descriptions
4.1 Input/Output Connections
The connection points are described in Section 4.1.1 through Section 4.1.8.
4.1.1 J1 – V
IN
Input power 5 V ±100 mV, return at J2.
4.1.2 J2 – GND
Return for input power, input at J1.
4.1.3 J3 –JTAG
Factory use only.
4.1.4 J4 – Serial Interface
Factory use only.
4.1.5 J5 - Micro USB
Input power connector.
4.1.6 JP1 – NTC
The connection point for the external temperature sensor. See the datasheet for more information.
4.1.7 JP2 – LED Mode
External connection for LED MODE resistor, if R23 is removed.
4.1.8 JP3 – FOD / PMOD Enable (Not Used)
If LOSS_THR resistor (Pin 43 to Gnd) is used, JP3 can be used to Enable or Disable FOD / PMOD. See
the datasheet (SLUSBD6) for additional details.
3
SLVU928A–September 2013–Revised October 2013 bq500212A bqTESLA Wireless Power TX EVM
Submit Documentation Feedback
Copyright © 2013, Texas Instruments Incorporated