User manual
Plug in a control card
›
Plug one of the control cards into the power board in such way that the control card "noses" goes
through the drillings on the power board (see Figure 1)
Step by step installation guide for XMC™ digital power explorer kit
Install DAVE™
DAVE™ is a free and powerful eclipse-based development platform for XMC™ soware development.
DAVE™ includes GCC compiler from GNU, DAVE™ code engine for automatic code generation and GDB
debugger from GNU. DAVE™ oers pre-defined and tested SW components -DAVE™ APPs- and XMC™
Lib - Low Level Drivers (LLDs)- that accelerate the application soware creation.
To install DAVE™ follow these steps:
›
Download and execute the latest version of DAVE™ installation file from www.infineon.com/DAVE
›
Follow the installation guidelines that are included in the download package
STEP 1
STEP 2
Figure 1
Load banks
IMPORTANT NOTE: The power board contains resistive load banks (Figure 1).
These loads are purely resistive and during operation may become hot. To prevent
injuries, special care is advised when touching the on-board resistor banks during
the operation. Any other kind of load, including other resistors, can be connected to the connector "V
out
" for
the purpose of further test or evaluation (blue connector). Using this kit without taking necessary measures
for cooling and isolating external loads may cause personal injuries. This evaluation board is intended for
use only by qualified and skilled technical sta for laboratory usage. Please read disclaimer page carefully
before using this kit.