W0802P Specification V1.0 Beijing Winner Microelectronics Co., Ltd. (winner micro) Address: 18th Floor, Yindu Building, No.67 Fucheng Road, Haidian District, Beijing, China Tel: +86-10-62161900 Website: www.winnermicro.
Document History Version V1.
Content 1 Introduction ................................................................................................................................................. 1 2 Product Feature.......................................................................................................................................... 1 2.1 Interface ...................................................................................................................................... 1 2.2 Wireless..............
Introduction 1 W0802P is the IoT Wirless module based on Wi-Fi SoC W800. It integrates stamp hole interface and PCB antenna. This module can be used for smart home, smart appliance, smart toy and industry field. 2 2.1 Product Feature Interface Stamp hole interface with 1.5mm spacing Integrate 5 x UART ports, band rate 1200bps~2Mbps 2.2 Integrate 2 channel 16bit ADC Integrate PWM 1 x I²C 1 x Duplex I²S Max 18 GPIO Wireless Support GB15629.11-2006、IEEE802.
2.3 3 Support IEEE802.11n MCS 0~7, MCS32 transmission rate is up to 150Mbps Support Short Preamble in 2/5.
1Mbps@-93dBm； 11Mbps@-87dBm； Reception Sensitivity 54Mbps@-73dBm； 20MHz MCS7@-71dBm； Data Rate in PHY 802.11n MCS 0~7 150Mbps Modulation Mode DSSS、OFDM、DBPSK、DQPSK、CCK、QAM16/64 IEEE802.11b, DSSS 1Mbps, POUT = 18±2dBm； Output Power IEEE802.11g, OFDM 54Mbps, POUT = 14±2dBm； IEEE802.11n, OFDM MCS7, POUT = 12±2dBm； Interface UART, SPI, GPIO, PWM, I²C, I²S 2Mbps@UART (Max) Interface Rate 50Mbps@SPI (Max) Hardware Working Voltage 3.0V – 3.
4 Network Protocol TCP/UDP/ARP/ICMP/DHCP/DNS/HTTP Interface Protocol AT+Command Interface Module is shown in Figure4-1: Figure 4-1 W0802P Table 4-1 PIN Description NO.
5 PA7 I/O GPIO,INPUT PWM4/LSPI_MOSI/I²S_MCK/I²S_DI 6 PB0 I/O GPIO, INPUT PWM0/LSPI_MISO/UART3_TX 7 PB1 I/O GPIO, INPUT PWM1/LSPI_CK/UART3_RX 8 VDD P 3.
5 Reference Circuit Design Figure 5-1 W0802P Reference Design 6 Appendix: Statement Federal Communications Commission (FCC) Declaration of Conformity FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment. This device complies with Part 15 of the FCC Rules.Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2.
uncontrolled rolled environment. This equipment should be installed and operated with minimum distance 20cm between the radiator and your body. Important Note：This radio module must not installed to co-locate and operating simultaneously with other radios in host system except in accordance with FCC multi-transmitter product procedures. Additional testing and equipment authorization may be required to operating simultaneously with other ra-dio.
