Installation Guide
WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. JUNE 23, 2016 3:18 PM
waclighting.com
Phone (800) 526.2588
Fax (800) 526.2585
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
4
STEP 1: DETERMINE MOUNTING POSITION
*Note: Transformer is required to power the xture. (sold separately)
1. Make sure the main power supply to your transformer
is turned o.
2. Install a 4’’ by 2’’ junction box, and ensure it is water-tight
for outdoor use.
3. Secure the mounting bracket to the junction box using
two 8-32 junction box screws.
4. Connect the xture wires to the landscape wires from the
transformer using the wire nuts provided.
5. Place all wiring and connectors back in the junction box.
6. Use the rubber washer and mounting screw to install and
secure the xture to the mounting surface.
Note: It is recommended that the installer run a bead
of clear, outdoor-rated silicone (GE RTV-162 or
equivalent, provided by others) caulk between
gasket or back of xture and mounting surface to
prevent seepage of water into xture)
Mounting Bracket
Junction Box
Screws
Mounting Surface to prevent seepage of water into xture
Wire Nuts
Rubber Washer
INSTALLATION INSTRUCTION
Step and Wall Light
4021