Installation Sheet

WAC Lighting
www.waclighting.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. JAN 2018
WIRING MULTIPLE UNITS:
In addition to hard wiring multiple xtures, components are provided to allow xtures to be linked through surface wiring.
a. End to End Connection with I-Connector (One included with each light bar):
The I-Connector allows two xtures to be connected end to end. I-Connector has one square and two round pins to
ensure the correct orientation.
NOTE: The total number of all connected xtures should not exceed 6 pieces for BA-I.
1. Pry out the plastic covers concealing the female connection ports at the end of the xtures.
2. Insert one end of the “I” connector into the rst xture. Slide the second xture into the rst one.
3. Secure the position of the second xture by using two mounting screws.
Jumper Wire
I-Connector
Cover Bracket
b. Connection with interconnect cable (Sold Separately):
A jumper wire allows multiple units to be linked through surface wiring.
The jumper wire has one square and two round pins to ensure the correct orientation.
NOTE: The total number of all connected xtures should not exceed 4 pieces for BA-IC12, BA-IC24. 3 pieces for BA-IC36
1. Pry out the plastic covers concealing the female connection ports at the end of the xtures.
2. Insert the ends of the connectors into each xture.
3. Jumper wires have metal strain relief cover brackets. Slide the cover bracket over the connector. Position the bracket so that the hole
in the bracket aligns with the hole in the xture. Use the screw supplied to secure the cover bracket to the xture.
4. Wrap excess wires using wire ties if necessary.
CCT SWITCHING OPTION
Fixture’s CCT can be set to 2700K or 3000K by
pressing the switch on the xture as shown:
I : 2700K
O: OFF
II : 3000K
INSTALLATION INSTRUCTION
AC-LED LEDme® Light Bars
BA-ACLED8, BA-ACLED12, BA-ACLED18, BA-ACLED24, BA-ACLED30, BA-ACLED36, BA-ACLED42