Installation Sheet

WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. JULY, 2016
waclighting.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
INSTALLATION INSTRUCTION
Tube Architectural - Ceiling Mount
DS-CD05, DS-CD06, DS-CD08
REFLECTOR REPLACEMENT
1. Remove panel assembly by loosening the xture screw and gasket, remove three chips to change reector. (FIG.4)
2. Replace your beam angle reector on panel and x the clips. (FIG.5)
LED REPLACEMENT
1. Loosen the xture screw and gasket (FIG.6), remove the panel assembly (FIG.7).
2. Loosen the LED holder and LED screws, carefully disconnect LED connector from driver connector and replace LED by
removing driver mounting screws. (FIG.8).
DRIVER REPLACEMENT
1. Loosen the xture screw and gasket (FIG.9), remove the cover assembly (FIG.10).
2. Loosen the LED driver screws, carefully disconnect LED driver connector from LED connector and replace driver by removing driver
mounting screws. (FIG.11).
COMPLETING THE INSTALLATION
To prevent moisture from entering the outlet box and causing a short, use clear caulking (i.e. indoor/outdoor silicone sealant) to outline the
outside of xture plate where it meets the wall leaving a space at bottom to allow moisture a means to escape.
Remove three clips
Replace dierent
beam angle reector
Loosen the xture
screws and gaskets
Loosen the xture
screws and gaskets
Remove panel
assembly
Remove panel
assembly
LED holder
LED holder
Screws
Connector
LED
Put on reector
and x clips
FIG.4
FIG.6
FIG.9
FIG.7
FIG.10
FIG.8
FIG.11
FIG.5