Installation Guide

WAC Lighting
www.waclighting.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. JULY, 2014
INSTALLATION INSTRUCTION
100W/150W Non-Enclosed Electronic Transformer
EN-12100-R-AR, EN-12150-R-AR
CAUTION – TO REDUCE RISK OF FIRE AND ELECTRICAL SHOCK
• Always turn o power at main switch prior to installation.
• Intended for installation by a qualied electrician.
• System is intended for installation in accordance with National Electric Code, and local regulations.
Consult with local inspector to assure compliance.
EN-12100-R-AR EN-12150-R-AR
MAX LOAD 100W 150W
MIN LOAD 35W 50W
INPUT VOLTAGE 120V 120V
INPUT CURRENT 0.83A 1.3A
OUTPUT VOLTAGE 11.6V 11.6V
MAX CASE TEMP 90º C (194ºF)
AMBIENT TEMP -20º C ~ +50º C (-4ºF ~ 122ºF)
FEATURES
• Radio disturbance suppression.
• Electronic short circuit protection with auto reset.
• Overload protection with auto reset.
• Soft start delay to preserve bulb life, for use with tungsten lament lamps.
• Dimmable with electronic dimmer switches.
INSTALLATION:
1. Use #14 AWG (minimum) wire for output wire.
2. Transformers must be installed away from heat sources and accessible for service.
3. Unit is a UL listed component for replacement installation, requires enclosure.
4. Dimmer switches install on the primary side.
5. Connect building wires to like color transformer wires with wire nuts. Building ground wire may be green or un-insulated, and
attaches to ground screw on enclosure.
6. Connect out put wires from transformer to xture wires with wire nuts. Wires to xtures may be chain wired or “ home run”
wired back to the transformer. High frequency output is only readable with a true RMS meter with sucient range capability.
MAXIMUM LENGTH / VOLTAGE DROP GUIDELINE
WIRE SIZE LOAD
35 W 50 W 60 W 100 W 150 W
14 GAUGE 21 FT 19 FT 15 FT 14 12
12 GAUGE 28 FT 25 FT 21 FT 19 17