Installation Sheet

ManualsBrandsWAC Lighting ManualsElectronic TransformersClass II Enclosed 60W 12V Electronic Transformer

Retain these instructions for future service and adjustments

44 Harbor Park Drive, Port Washington, NY 11050

Tel: (800) 526-2588 Fax (800) 526-2585

www.waclighting.com

INSTRUCTIONS Class II Electronic Transformer

Model EN-1260-RB2

CAUTION – TO REDUCE RISK OF FIRE AND ELECTRICAL SHOCK

 Always turn off power at main switch prior to installation.

 Intended for installation by a qualified electrician.

 System is intended for installation in accordance with National Electric Code, and local

regulations. Consult with local inspector to assure compliance.

MAX LOAD 60W

MIN LOAD 20W

INPUT VOLTAGE 120V

INPUT CURRENT 0.53A

OUTPUT VOLTAGE 11.6V

CASE TEMP

90ºC (194F)

AMBIENT TEMP

-20ºC TO 50ºC (-4F TO 122F)

FEATURES:

 Electronic short circuit protection with auto-reset.

 Overload protection with auto-reset.

 Automatic thermal regulation.

 Soft start delay to preserve bulb life, for use with tungsten filament lamps.

INSTALLATION

1. Use a minimum of #18 AWG for the output wire.

2. Transformers must be installed away from heat sources and accessible for service.

3. Note: Enclosed transformer is UL listed. The transformer box has a separate line volt,

and low volt wiring compartments. Trade size knock out are provided on both

compartments. Connect building wires to like color transformer wires with wire nuts.

Building ground wire may be green or un-insulated, and attaches to green wire from

transformer box.

4. Connect out put wires from transformer to fixture wires with wire nuts. Where multiple

fixtures are involved several fixtures wires can be joined by use of the same wire nut.

Wires to fixture

Summary of content (3 pages)

PAGE 1
INSTRUCTIONS Class II Electronic Transformer Model EN-1260-RB2 CAUTION – TO REDUCE RISK OF FIRE AND ELECTRICAL SHOCK  Always turn off power at main switch prior to installation.  Intended for installation by a qualified electrician.  System is intended for installation in accordance with National Electric Code, and local regulations. Consult with local inspector to assure compliance. MAX LOAD MIN LOAD INPUT VOLTAGE INPUT CURRENT OUTPUT VOLTAGE CASE TEMP AMBIENT TEMP 60W 20W 120V 0.53A 11.
PAGE 2
INSTRUCTIONS Class II Electronic Transformer Model EN-12300-RB2 CAUTION – TO REDUCE RISK OF FIRE AND ELECTRICAL SHOCK  Always turn off power at main switch prior to installation.  Intended for installation by a qualified electrician.  System is intended for installation in accordance with National Electric Code, and local regulations. Consult with local inspector to assure compliance. MAX LOAD MIN LOAD INPUT VOLTAGE INPUT CURRENT OUTPUT VOLTAGE CASE TEMP AMBIENT TEMP 5 X 60W 1 X 20W 120V 2.5A 11.
PAGE 3
9. es may be chain wired or “ home run” wired back to the transformer. High frequency output is only readable with a true RMS meter, with sufficient range capability. WIRE SIZE 18 GAUGE 16 GAUGE 14 GAUGE 12 GAUGE MAXIMUM LENGTH / VOLTAGE DROP GUIDELINE 35 WATT 50 WATT 10 FT 9 FT 14 FT 13 FT 21 FT 19 FT 28 FT 25 FT 60 WATT 8 FT 11 FT 15 FT 21 FT Retain these instructions for future service and adjustments 44 Harbor Park Drive, Port Washington, NY 11050 Tel: (800) 526-2588 Fax (800) 526-2585 www.