Installation & Assembly

WAC Lighting
www.waclighting.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. JULY, 2014
INSTALLATION INSTRUCTION
900 Series LED Quick Connect™ Socket Set
QP-LED903
OVERVIEW:
Pendant sockets sets are designed for use with all WAC quick
connect adapters. They may also be used on other manufacturers
brand of quick connect (consult factory for compatibility).
Pendants may be mounted to monorail, monopoints, line volt
exible track or standard line volt track, by coupling to a low voltage
quick connect adapter. Sockets are supplied with a 6’ cable and may
be eld cut to desired length.
INSTALLING LAMP & SHADE:
1. Remove the quick connector adapter (see page 2,
to shorten pendant).
2. The small collar travels any where along the length of
the socket shaft and is secured by a setscrew. This allows
varying lamp positions inside the shade. Set the collar
to a desired height. (gure 1)
3. Lower the shade until it rests on the nial.
4. Re-install the quick connect adapter. If shortening the pendant
do this before re installing (see page 2, to shorten pendant).
INSTALLING PENDANT TO QUICK CONNECT:
5. Insert the post of the quick connect into the quick connect
adapter. ( gure 2 )
6. Thread the top half of the conical section until it seats
with the adapter.
7. Adjust xture position, use caution not to loosen
the conical section.
See p.2 for eld shortening pendants.
FIXTURE 1