Installation Sheet

WAC Lighting
www.waclighting.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. APRIL, 2015 2
Fixture installation for H/ L/ J Track: (1035/1052) (Fig.2)
1. The track has a groove running its length to indicate polarity and the locking tab has an arrow indicating locking direction.
2. Insert adapter into track slot and rotate it 90°. The arrow should point to the grooved side of the track.
3. Push up and turn the locking tab into the lock position.
4. Reverse procedure to remove. Track heads may be positioned anywhere along the track.
ACCESSORIES (Fig.4)
1. Use a screw-driver to loosen the two screws at the back of the fixture body.
2. Take out the front frame, then change the lens.
3. To install cross louver or snoot, use the clips around the front frame to fasten them directly.
INSTALLATION INSTRUCTION
Exterminator II LED Track Luminaires
H-1014/1035/1052, L-1014/1035/1052, J-1014/1035/1052
360°
±90°
Snoot
Screw
Lens
Front Frame
Cross Louver
FIXTURE POSITIONING: Fig.3
5. Power on fixture, rotate the luminaire’s body horizontally or vertically to aim it properly. The fixture can rotate
±90°vertically and 360 °horizontally.
Fig.2
Fig.4
Fig.3
locking tab