Installation Sheet

4/4
Retain these instructions for future service and adjustments
44 Harbor Park Drive, Port Washington, NY 11050
Tel: [phone] Fax [phone]
www.waclighting.com
Installing Fixtures:
1. Remove the cap
ring on the
fixture adapter.
2. Raise the open
end of the
adapter to the
rail.
3. Re-install the
cap ring.
Joining rails:
1. Mount the rod to the ceiling.
2. Unscrew the cap ring, and withdraw the
internal connector by pulling straight down.
3. Loosen the bottom & side screws on the
connector.
4. Insert the rail ends into the connector.
5. Tighten the setscrews on both sides, and the
bottom screws.
6. Raise the connector into the upper cover, and
secure with the cap ring.
Note: To ensure good electrical connection, make
sure the bus- wires are always flush with the rail
end.
Field Cutting:
1. Rail may be cut with a power or hack saw.
2. File rough edges and brush out and debris.
3. Install end cap over cut end.
Note: A field cut rail will not be able to join another
rail section unless provisions are made to recess
the aluminum core. It easier to make a field cut on
the end of the last piece.
Support rod
Flexrail1
Side screw
Internal connector
Bottom screws
Cap ring
Cap ring
Flexrail1
Fixture adapter
Transformer