Installation Sheet

1WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. NOVEMBER, 2015
waclighting.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
INSTALLATION INSTRUCTION
Tesla 2” LED - Non-IC Remodeling Housing
HR-2LED-R14D
SAFETY INSTRUCTION
IMPORTANT: NEVER attempt any work without shutting off the electricity.
• Read all instructions before installing.
• System is intended for installation by a qualified electrician in accordance with the National Electrical Code and local regulations.
• Go to the main fuse box, or circuit breaker. Place the main power switch in the “OFF” position and unscrew the fuse(s) or switch “OFF” the
circuit breaker switch(es) that control the power to the fixture or room that you are working on.
• Place the wall switch in the “OFF” position.
AVERTISSEMENT
• IMPORTANT : Coupez l’électricité avant TOUTE manipulation.
• Lisez toutes les instructions avant d’installer.
• Système est destiné à être installé par un électricien qualifié en conformité avec le code national de l’électricité et les règlements locaux.
• Accédez au panneau central de disjoncteurs ou de fusibles de votre demeure et placez l’interrupteur principal en position d’arrêt (« OFF »).
• Placez l’interrupteur mural en position d’arrêt (« OFF »).
OVERVIEW
Housing is remodel, NON-IC type. Housing requires a trim for finished look. Check catalog for various trim choices.
HOUSING INSTALLATION:
1. Cut out a hole 3s” in the existing ceiling (Fig.1) . Note: 2” maximum ceiling thickness
2. Pull ceiling wire through the hole (Fig.2).
3. Remove fixture junction box door and connect fixture wires to building wires: insert each supply wire into appropriate junction box
connector. This fixture features electronic low voltage (ELV) or 0-10V dimming capabilities. To utilize ELV, wire black (line hot) and white
(line neutral) in accordance to dimmer specifications. To utilize 0-10V dimming, wire purple (dim+), gray (dim -), black (line hot),
white (line neutral) in accordance to dimmer specifications. Green fixture wire to ground (Fig.3).
4. Place all wiring and connectors back in wiring box and replace junction box door (Fig.4).
Fig.1 Fig.2
Fig.3 Fig.4
Dim + purple (0 - 10V)
Dim - gray (0 - 10V)
Black / Hot
Green / Ground
White / Neutral
Cutout: 3s”