Installation Sheet

2
WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. OCT 2019
waclighting.com
Phone [phone]
Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive
Port Washington, NY 11050
Central Distribution Center
1600 Distribution Ct
Lithia Springs, GA 30122
Western Distribution Center
1750 Archibald Avenue
Ontario, CA 91760
CCT SELECTION FIG.2
1. Before beginning the installation, adjust the CCT of each
fixture to the desired color temperature.
2. Turn each fixture to the back side and use the switch to
select between a 2700K, 3000K or 3500K color
temperature.
SURFACE MOUNTING (FIG.3, FIG.4, FIG. 5
FIG.1 INSTALLATION AND WIRING
INSTALLATION INSTRUCTIONS
LED UNDERCABINET PUCK LIGHTS
HR-AC71, HR-AC72, HR-AC73
Power Cable Dual Cable Puck Light End Cable Puck Light
CCT Selection Switch
FIG.2
1. Push on the back side of each fixture to remove the trims from
the housings (FIG. 3).
2. Mount the housings at the desired installation locations (FIG 4).
Note: Please refer to the cable lengths on Page 1 when
determining housing locations. Plan accordingly to make sure
lead cables are long enough to reach next puck light.
3. Route the cables through the cable slots in the housing. If
possible, you may also drill 2" holes through the mounting
surface and route your cables above the surface (FIG. 5).
4. Push your trim into the housing and connect to power cord or
previous fixture. Plug in power cord to a wall outlet once
installation is complete.
FIG.3 FIG.4
Cable can be routed along mounting surface
or routed above is access permits
FIG.5
RECESSED MOUNTING (FIG.3, FIG.6, FIG. 7)
1. Push on the back side of each fixture to remove the trims from
the housings (FIG. 3).
2. Determine desired installation locations and drill a 2 b" hole
for each puck light.
Note: Please refer to the cable lengths on Page 1 when
determining housing locations. Plan accordingly to make sure
lead cables are long enough to reach next puck light.
3. Route the cables through the drilled hole (FIG. 6).
4. Push your trim into the hole and connect to power cord or
previous fixture. Plug in power cord to a wall outlet once
installation is complete (FIG. 7).
Ø2 b"
FIG.
6
FIG.7