Installation Sheet

WAC Lighting
www.waclighting.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. JUNE, 2014
INSTALLATION INSTRUCTION
LEDme® Class 2 Electronic Drivers
LD-700MA03-EDIM-IS
SAFETY INSTRUCTION
To reduce the risk of re, electric shock or injury to persons:
• Always turn o power at main switch prior to installation.
• System intended for installation by a qualied electrician, in accordance with NEC and local regulations.
Consult with local inspector to assure compliance.
• For use with LED loads.
Model LD-700MA03-EDIM-IS
Input Voltage 120V ac,60Hz
Input Current Max 0.04A
OUTPUT CURRENT 700mA
Port Output Voltage 2-4V DC
Port Load 1PC 1x3W LED Fixtures
Port Load Lead Wires 12-22AWG
Output Port 1 PCS
FEATURES:
• 700mA constant current for LED’s optimized and stable performance.
• Capable of supplying power to a single LED xture.
• Special circuit design to protect LED from high voltage pulse. driver will automatically shut o if the xtures
are not properly wired. In this event, unplug and check the wiring and then plug it in again.
• For use with ELV dimmer.
INSTALLATION:
1. Loosen two cover screws and remove the cover. Inside there one sets of wiring terminals.
2. Push down one set of the wiring terminals and insert xture’s red wire into the “+” terminal and the black wire into
the “-” terminal.
3. After connecting all the LED xtures, secure the cover by tightening the two screws.
4. The product should be installed on the either internal or external surface of any indoor construction.
MOUNTING INSTRUCTIONS