Installation Instructions

44 Harbor Park Drive
Port Washington, NY 11050
Tel: [phone]
Fax: [phone]
www.waclighting.com
Field Cutting Track
Measure the length of track needed, allow for the length of the live end or other connector.
Work at floor level. Note the polarity of the track (the groove in the track indicates the two wire side).
Identify the side that accepts the live end connector.
1. Brace the opposite end of track against a solid surface. Insert the live end and secure by tightening
the screw.
Fixture Installation
1. Note the track head contacts, and the polarity groove running the length of the track.
2. The two contacts should be positioned so that when rotated, they will face the grooved side of the
track (this is the side with two flat copper wires running it’s length).
3. Insert adapter into track slot. Pull downward on the adapter while rotating the adapter 90º.
4. Release the adapter so the locking tab seats in the track slot.
5. Removal is the reverse procedure. Track heads may be positioned anywhere along the track
length.
Secure this screw