Installation Guide

06/05/06
INSTRUCTIONS: Line Voltage Track Fixture
Model: JTK-104
Caution:
Read all instructions before installing.
Switch off power before installing or re-lamping.
Do not attempt to energize anything other than a track light fixture.
All installation shall be in accordance with NEC and all local codes.
Overview:
Fixtures are designed for use on “J” series W.A.C. Lighting track. They may also be used on other
manufacturer’s brand of track (consult factory for compatibility).
Retain instructions for future reference.
Installing Lamp & Shade:
1. Fixture is supplied with a 120 volt MR16
lamp with GU10 base, 50Watt maximum.
(Not suitable for other types of lamps.)
2. Insert lamp into the shade so the lamp pins
protrude through the back.
3. Place pins in the socket holes and twist
1/4" to the right. The lamp should feel firmly
seated.
4. Seat the lamp under the “V” spring of the
gimbal ring.
Fixture Installation
1. Note the track has a groove running it’s
length to indicate polarity.
2. Note the arrow on the locking tab.
3. Insert adapter into track slot and rotate it
90° The arrow should point to the
grooved side of the track.
4. Make sure the locking tab seats in the
track slot.
5. Removal is the reverse procedure. Track
heads may be positioned anywhere along
the track length.