Installation Sheet

WAC Lighting
www.waclighting.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. JULY, 2014
INSTALLATION INSTRUCTION
802 Low Voltage Track Luminaires
HHT-802, LHT-802, JHT-802 (Available in LED)
CAUTION:
Read all instructions before installing.
Switch o power before installing or re-lamping.
Do not attempt to energize anything other than a track light xture.
All installation shall be in accordance with NEC and all local codes.
OVERVIEW:
Fixtures are designed for use on on WAC “L” , “H”, “J” series track.
They may also be used on other manufacturer’s brand of track
(consult factory for compatibility).
LAMPING:
1. Use dimmable MR16 Lamp (LED Lamp included when
purchased as LED).
2. Remove the check ring.
3. Insert the MR16 lamp by aligning the pins with the holes in the
ceramic socket, and pushing straight in.
4. Re-install the check ring.
FIXTURE INSTALLATION
1. Note the track has a groove running its length to indicate polarity.
2. Note the slant of the locking tab.
3. Insert adapter into track slot and rotate adaptor 90º so that the low
side of the locking tab faces the grooved side of the track.
4. Make sure the locking tab seats in the track slot.
5. Removal is the reverse procedure. Track heads may be positioned
anywhere along the track length.
6. Not suitable for use on wall mounted track.