Specification Sheet

Fixture Type:
Catalog Number:
Project:
Location:
WAC Lighting
www.waclighting.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Avenue • Ontario, CA 91760
Phone [phone] • Fax [phone]
WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. APR 2014
InvisiLED® Pro
Accessories
POWER SUPPLY ACCESSORIES Model # Dimensions Description
Wiring box
with switch
TB-S
64” × 1s” × 14”
Use when spanning a large gap in a system layout
without leaving exposed wiring (ie: lighting kitchen
cabinets on both sides of a sink or window).
Low voltage wiring is collected inside box,
with Romex® wire output to go behind a wall.
Low Voltage
Wiring Box With
Feed
LED-TC-B2
12” × w” × s”
Wiring terminal for 24V InvisiLED with
2" female feed.
Low Voltage
Wiring Box
LED-T-B
12” × w” × d”
Neatly house up to 2 wires.
Lead Wire
LED-TC-P-2
LED-TC-P-12
2'
12'
Alternative length of lead wires for plug-in or
remote power supply. May be eld cut for use
with a remote power supply.
Extension Cable LED-TC-EXT-144 12' Use to extend the distance between power supply
and tape section.
TAPE LIGHT ACCESSORIES Model # Dimensions Description
Joiner Cable LED-TC-IC2
LED-TC-IC6
LED-TC-IC12
LED-TC-IC36
LED-TC-IC72
2"
6"
12"
36"
72"
Connects two sections of InvisiLED® Pro.
4-Way "X"
Connector
LED-TC-X
3w” × 3w” × c”
center: w”
arms: 12” each
"X" connector has one male and
three female connectors.
(Total run length power consumption cannot exceed
transformer load when "X" connector is used).
3-Way "Y"
Connector
LED-TC-Y
3z” × 3z” × c”
center: w”
arms: 12” each
"Y" connector has one male and
two female connectors.
(Total run length power consumption cannot exceed
transformer load when "Y" connector is used).
"L" Connector
LED-TC-L
1a" × 1c" × 4"
"L" connector has male and female connectors,
use to create 90° right angles.
End cap
LED-TC-EC
2" × 4" × x"
2" × 2" × 8"
Includes 1 cut end cap and 1 male end cap.
Use to terminate every run to protect
against contaminants.
Mounting Clips
(10 pack)
LED-T-CL
2"
For installation on surfaces that are dicult
to adhere to. Two mounting clips per foot
are recommended for straight runs.
Retrot Channel
LED-T-RC
36" × 2" × 2"
Use to construct a miniature cove or light bae
in which tape may be concealed. May also be
mounted to the channel as a way to change
the direction of the projected light.
Rigid Aluminum
Channel
LED-T-CH
5' × n” × a”
Mounting channel with acrylic diuser.