Installation Instructions

2/2
Retain these instructions for future service and adjustments
615 South Street, Garden City, NY 11530
Tel: [phone] Fax [phone]
www.waclighting.com
Function：
Once the wireless controller and the master controller are paired, the master controller will respond to the
remote control functions. To operate the remote control, please refer to the remote control instruction sheet.
Connect the slave controller to the master controller as follows:
Caution：One master controller can be connected to several slave controllers. In order to avoid duplicate
signals, the same network cannot have more than one master controller in operation. Do not open the control
box unless you are a professional electrician.Do not install under water.
Master Controller Slave Controllers
Remote power supply
Sample Layout
A EN-O24100-RB2-T Remote power supply
B LED-TO24-IC6 Joiner cable
C LED-TO24-CM Master controller
D LED-TO24-CS Slave controller
E LED-TO24-SW60 Palette signal wire
F LED-TO24-IC72-RGB RGB Joiner cable
G LED-TO24-WS Palette wireless controller
H LED-TCO-1-RGB 1 foot Palette tape section
I LED-TO24-X-RGB Palette X connector
J LED-TCO-10-RGB 10 foot Palette tape section
K LED-TO24-EC End cap
L LED-TO24-Y-RGB Palette Y connector
M LED-TCO-5-RGB 5 foot Palette tape section