Installation Sheet

WAC Lighting
www.waclighting.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. JULY, 2014
INSTALLATION INSTRUCTION
900 Series Quick Connect™ Socket Set
QP-902
INSTRUCTIONS PERTAINING TO A RISK OF FIRE, OR INJURY
Lighted lamp is HOT!
SAFETY INSTRUCTION
To reduce the risk of FIRE OR INJURY:
• Turn o all power and allow to cool before replacing lamp.
• Lamp gets HOT quickly! Contact only switch/plug when turning on.
• Do not touch lens, guard, or enclosure.
• Keep away from materials that may burn.
• Do not touch the lamp at any time. Use a soft cloth. Oil from skin may
damage lamp.
• Do not operate the luminaire with a missing lens or damaged shield.
• Save these instructions.
OVERVIEW
Pendant sockets sets are designed for use with all
WAC Quick Connect™ adapters. They may also be used on other
manufacturers brand of quick connect (consult factory for compatibility).
Pendants may be mounted to monorail, monopoints, line volt exible track
or standard line volt track, by coupling to a low voltage quick connect
adapter. Sockets are supplied with a 6”cable and may be eld cut
to desired length.
INSTALLING LAMP & SHADE:
1. Insert lamp 12V 50W max. bi-pin Xenon,
2. (not tungsten halogen) into the socket ( supplied with 12V, a 24 volt
lamp may also be used with appropriate power supply).
3. Remove the quick connector adapter (see shortening pendant).
4. The small collar travels any where along the length of the socket shaft
and is secured by a setscrew. This allows varying lamp positions inside
the shade. Set the collar to a desired height.
5. Lower the shade until it rests on the nial.
6. Re-install the quick connect adapter. If shortening the pendant do this
before re installing (see shortening pendant).
INSTALLING PENDANT TO QUICK CONNECT:
1. Insert the post of the quick connect into the quick connect adapter.
2. Thread the top half of the conical section until it seats with the adapter.
3. Adjust xture position, use caution not to loosen the conical section.
See p.2 for eld shortening pendants.