Installation Sheet

WAC Lighting
www.waclighting.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. JULY, 2014
TO INSTALL/ SHORTEN PENDANT:
All Pendant shades use the quick connect adapter to attach to the rail. On the QP-902 the mating piece (top conical section) for
quick connect adapter comes uninstalled. Feed the cable end through the glass shade and the metal nial. If cable needs to be
shortened, make the cut now. To install the top conical section, follow the step-by-step instructions bellow. NOTE: PENDANT
CABLES ARE CO-AXIAL, IF THE LOWER SCREW IN STEP 4 IS MADE TOO TIGHT, THE INNER AN OUTER WIRE WILL SHORT.
A SHORT CIRCUIT WILL RENDER THE ENTIRE SYSTEM IN-OPERATIVE AND POSSIBLY DAMAGE THE TRANSFORMER.
CHECK ALL PENDANT SPLICES FOR CONTINUITY BEFORE INSTALLING.
CHECK SPLICE:
Before mounting, with lamp removed from the
socket, check for continuity. There should be none.
Insert lamp in socket and re-check. There should
now be continuity, indicating a completed circuit.
Install with power o.
Make a clean cut. Slide brass
collar over wire.
Trim 1/8” of insulation from the
inner wire. Position the collar so
that a small section (1/16”) of
braided wire protrudes from the
top of the collar.
Feed inner wire until it reaches
the top set screw position.
Feed braided outer wire and
collar into bottom portion.
INSTALLATION INSTRUCTION
900 Series Quick Connect™ Socket Set
QP-902
Tighten top setscrew rst then
lower. Smooth out any bulges in
braided wire. Perform continuity
check before mounting.