Installation Sheet

WAC Lighting
www.waclighting.com
Phone [phone] • Fax [phone]
Headquarters/Eastern Distribution Center
44 Harbor Park Drive • Port Washington, NY 11050
Phone [phone] • Fax [phone]
Western Distribution Center
1750 Archibald Ave • Ontario, CA 91761
Phone [phone] • Fax [phone]
WAC Lighting retains the right to modify the design of our products at any time as part of the company's continuous improvement program. JUNE, 2014
INSTALLATION INSTRUCTION
Mini LED Multiple Spots - Remodel
MT-3LD111R-F30, MT-3LD211R-F30, MT-3LD311R-F30
SAFETY INSTRUCTION
IMPORTANT: NEVER attempt any work without shutting o the electricity.
1. Read all of these instructions before installing the track system.
2. System is intended for installation by a qualied electrician in accordance with the National Electrical
Code and local regulations.
3. Go to the main fuse box, or circuit breaker. Place the main power switch in the “OFF” position and unscrew the fuse(s) or
switch ”OFF” the circuit breaker switch(es) that control the power to the xture or room that you are working on.
4. Place the wall switch in the “OFF” position.
INSTRUCTIONS DE SÉCURITÉ IMPORTANTES
1. Lisez toutes les instructions avant d’installer.
2. Système est destiné à être installé par un électricien qualié en conformité avec le code national de
3. l’électricité et les règlements locaux.
4. Accédez au panneau central de disjoncteurs ou de fusibles de votre demeure et placez l’interrupteur principal en position
d’arrêt («OFF »).
5. Placez l’interrupteur mural en position d’arrêt (« OFF »).
REMODEL HOUSING MOUNTING:
1. Cut out a hole in the existing ceiling (as Fig.1).
2. Pull ceiling wire through the hole (as Fig.2).
3. Junction box is suitable for chain wiring of multiple xtures
and is supplied with a slide latch door, and two trade
size knockouts connectors.
4. Remove junction box door and connect xture wires
to building wires: insert each supply wire into appropriate
junction box connector. Connect black xture wire
to hot wire, white xture wire to neutral wire and
green xture wire to ground (as Fig.3 and Fig.4).
5. Place all wiring and connectors back in wiring box
and replace junction box door.
6. Push the housing up through the hole (as Fig.5).
7. Push clips to secure the xture. Note: 1 inch maximum
ceiling thickness (as Fig.6).
8. Push the trim assembly up until the trim ring is ush
to the ceiling (as Fig.7, Fig.8, Fig.9 and Fig.10).
USE TEMPLATE SUPPLIED TO MAKE APPROPRIATE CUTOUT.
Model Cutout
MT-3LD111R-F30
4 8” x 4 8”
MT-3LD211R-F30
8 4 x 4 8”
MT-3LD311R-F30
12 x” x 4 8”